"Wisconsin's Premier Supplier to the Laminate and Woodworking Industries"
Caulk Application Instructions
Back Splash
- Knead tube before using.
- Surfaces must be clean and free of dust, dirt, oil and other substances.
- Remove all old caulking if necessary prior to application.
- Place bead of FormFill Adhesive & Caulk in area to be sealed. Bead should be approximately 1/8" x 1/8" to avoid waste.
- Using moderate pressure use a caulking tool or moist finger to remove excess caulk. Some shrinkage will occur as product cures.
- Product cleans up with water.
- Do not allow product to freeze.
Counter Top Joints
- Knead tube before using.
- Ensure the two surfaces of the joint are clean and dry.
- Apply a thick bead of FormFill Adhesive & Caulk to one side of the joint and spread evenly with a putty knife.
- Bring the two surfaces of the joint together and begin to tighten the draw bolts.
- Remove excess with damp cloth.
- Align the joint and finish tightening the draw bolts.
- Repeat step 5.
- Some shrinkage will occur during final drying. Reapply a light coat over seam and allow a short drying period and wipe down with damp cloth.
| Note: |